Set custom boundaries around your property that allows your dog to be safe in your yard. Installation: Fence Wire - The fence wire must make a continuous loop around your property for your system to operate. The signal is delivered from the terminal of the transmitter, through the fence wire, back to the other terminal on the transmitter. When this is accomplished, the wire continuity light will emit a constant red indicator. The wire should be buried approximately 4-6 inches into the ground, or deep enough to protect it from being damaged by any machinery or dug up by your dog. (The wire does not have to be buried in order to work.)
Wire Placement: CAUTION - Before you install your fence wire, contact the utility company to mark the utility lines on your property before you begin digging. Be sure to test your wire layout above ground before permanent installation begins.Carefully choose the areas in which you want to contain your dog. A diagram may be helpful in predicting unforeseen obstacles. IMPORTANT! When creating a Front Boundary Only, Fence Front Yard Only, or Front Boundary with Existing Fence type of e-fence system, THE TWO PARALLEL E-FENCE WIRES MUST BE 6-10 FEET APART to avoid any signal interference. Keep wires 6ft. apart to avoid signal interference.
Includes: Wall mounting transmitter, waterproof receiver, transmitter charger for receiver, underground fence wire 500 ft., 50 training flags, 4 waterproof splices, test light, ground wire, 2 transmitter mounting screws and 2 plastic anchors, plastic training probes, owner's manual, and training manual.
- Additional Information
- Community Q&A
Product QuestionsNo questions yet. Be the first to ask the question!