Med Aire Alternating Pressure Pump and Pad System

The Drive Med-Aire Alternating Pressure Pump and Pad System helps prevent and treat pressure ulcers. One hundred and thirty air cells inflate and deflate in an alternating pattern every five minutes. Pressure points restrict blood flow, reducing oxygen and nutrients to the skin and surrounding tissues. Restricting blood flow for too long leads to damaged cells, or over a length of time, causes cells to die, resulting in pressure ulcers (bed sores). For many individuals, pressure points are not a problem as they turn about on their bed, but for those with limited mobility, pressure points can cause problems.

This bubble pad's design is comfortable, encouraging patient compliance. Constructed from heavy-weight vinyl (PVC), it is durable and holds up to 300 pounds. It fits on top of a standard mattress and has built-in brackets to keep it in place. The Deluxe Model comes with end flaps that tuck underneath the bed for a more secure hold.

With the Drive Medical Med-Aire Alternating Pressure Pump and Pad System, you get your choice of a 110- or 220-volt pump with either fixed pressure or variable pressure. Pressure settings range from soft to firm to give the best comfort level.

Drive Medical supplies replacement parts for when you need to update or replace your pad or pump to keep your alternating pressure system working at its best.

Pump

*Do not put in liquid.

1. Inspect for damage.
2. Place on a table or other surface.
3. Clean the outside of the casing with a quaternary ammonium solution.
4. Do not use a spray to clean the pump.
5. Do not use any solution containing Hypocarbonate or Phenolic base.
6. Leave the cleaning agent on the pump for 10 minutes (or follow the instructions on the cleaner).
7. Moisten a clean cloth with the solution to cleanse the faceplate. Do not allow moisture to enter the faceplate or control panel or damage will occur.
8. Air dry completely.
9. Plug the pump in and test.

Bubble Pad

1. Remove blood using a one part bleach to nine parts water solution.
2. Let air dry for at least 10 minutes.
3. Dab with a moistened cloth.
4. Wipe surfaces using soap and water.
5. Rinse.
6. Air dry out of direct sunlight.

1. Lay the pad out on a bed with the inflation tubes near the foot of the bed.
2. Put down a cotton sheet to separate the surface from the user's skin.
3. Hook the pump to the bed frame or footboard.
4. Verify that the pump is securely attached.
5. Connect the bubble pad's inflation tubes to the pump's inflating nozzles.
6. Verify the connection.
7. Check the tubes for kinks.
8. Make sure that the tubes are clear of the bed and the pad.
9. Plug the power cord into a grounded electrical outlet.
10. Turn on the power by pressing the switch.