SAVE $10! on Qualifying Orders Over $75! Use Code: DROP10 | Exclusions Apply - Expires Soon!

Abdominal Pads

Abdominal Pads, also referred to as ABD Pads, are used for large wounds or for wounds requiring high absorbency. This abdominal dressing was originally developed for the military to treat battle wounds. ABD is an acronym for “Army Battle Dressing.” In fact, several abdominal wound dressings currently in use today were originally developed for battle field situations. Many people today associate this absorbent dressing as an abdominal wound dressing, including many doctors and caregivers. However, the actual purpose of ABD dressings is to manage heavy draining wounds or large wounds. ABD wound dressings are constructed with a thick absorbent layer that disperses fluids to keep them from pooling upon the wound site. The edges are sealed and the dressing back is designed to prevent strike-through.

Set Ascending Direction

8 Item(s)

Set Ascending Direction

8 Item(s)

Vitality Medical carries a wide assortment of ABD dressings from major medical manufacturers, including the Medline ABD Pads, Invacare ABD Gauze Pad, Covidien Tendersorb Wet Proof, Dukal Combine ABD Pad, and the Hartman Sorbalux ABD Pad.

Packing Wounds with the Emergency Bandage and ABD Pad

Video Transcript

Glove up before every rescue. If possible, immediately apply direct pressure to the wound or upstream of it while preparing your bandage.

Open the outer wrapper by tearing along the short edge of the packaging. Open the inner wrapper by tearing along the notch in the center of the package tail.

Open the ABD pad packaging by tearing along one corner. Unfold the bandage pad while keeping the bandage roll tight in one hand.

Crumple the ABD pad into a ball with your fists. Press the crumpled pad into the deepest portion of the wound. Do not press farther into the wound then you can see.

Place the pad of the emergency bandage directly onto the crumpled ABD pad maintaining pressure throughout. Begin wrapping the bandage keeping the rolled end as close as possible to the wrap.

Thread the bandage through the slot in the center of the d-ring which is attached to the back of the bandage pad. Continue to wrap the bandage and thread through the d-ring a second time.

Use the d-ring to reverse the direction of the wrap pulling the d-ring flat against the pad. Continue to wrap the bandage in a figure eight pattern.

Once the tail end is reached, tuck the windlass underneath and through the previous wrap. Rotate the windlass at least two full turns twisting the outer wrap around it in order to tighten the bandage to a level of pressure sufficient to stop the bleeding.

Attach at least one windlass end to an edge of the bandage wrap. Check that the bleeding has stopped.

Inspired by your history...